Download Motorola USB08 Operating instructions

E Clock Frequency
Select the E clock frequency at which the MCU is working. See the HC908 data sheet for the chip that
you are using. Those chips with an internal RC oscillator may be operating on either their internal
oscillator or on an external crystal.
Command Defaults
Bytes to List
Sets the default value for the number of bytes to list if the List command
(page 50) is issued with only a starting address.
Lines to Unassemble Sets the number of instructions to unassemble if the Unassemble command
(page 62) is issued with only a starting address.
Auto Connect at start-up
Tick this box so that Xplor8 automatically issues the Connect command when the program is launched
- see the Connect / Disconnect command on page 43.
Auto Reset after connect
Tick this box so that Xplor8 automatically issues the Reset command after connecting.
Auto unlock after reset
Tick this box to have Xplor8 automatically issue the Unlock command after resetting.
Use Forced Monitor mode
Tick this box if working with a fully-erased (or brand new) chip.
Associate the extension ".xp8" with Xplor8
Click this button to do as its caption says. When Xplor8 is first run, it automatically makes this
association, but if there is subsequently a problem with file associations, the link between the .xp8
project file type and the Xplor8 executable may be restored with this button.
32