Download Cisco Engine 611 Specifications

Chapter 3
CLI Commands
show ntp
show ntp
To display the NTP parameters for a WAAS device, use the show ntp EXEC command.
show ntp status
Syntax Description
status
Defaults
No default behavior or values.
Command Modes
EXEC
Device Modes
application-accelerator
Displays NTP status.
central-manager
Examples
Table 3-52 describes the fields shown in the show ntp status command display.
Table 3-52
Field Descriptions for the show ntp status Command
Field
Description
NTP
Indicates whether NTP is enabled or disabled.
server list
NTP server IP and subnet addresses.
remote
Name (first 15 characters) of remote NTP server.
*
In the remote column, identifies the system peer to which the clock is synchronized.
+
In the remote column, identifies a valid or eligible peer for NTP synchronization.
space
In the remote column, indicates that the peer was rejected. (The peer could not be
reached or excessive delay occurred in reaching the NTP server.)
x
In the remote column, indicates a false tick and is ignored by the NTP server.
-
In the remote column, indicates a reading outside the clock tolerance limits and is
ignored by the NTP server.
refid
Clock reference ID to which the remote NTP server is synchronized.
st
Clock server stratum or layer. In this example, stratum 1 is the top layer.
t
Type of peer (local, unicast, multicast, or broadcast).
when
Indicates when the last packet was received from the server in seconds.
poll
Time check or correlation polling interval in seconds.
reach
8-bit reachability register. If the server was reachable during the last polling interval,
a 1 is recorded; otherwise, a 0 is recorded. Octal values 377 and above indicate that
every polling attempt reached the server.
delay
Estimated delay (in milliseconds) between the requester and the server.
Cisco Wide Area Application Services Command Reference
OL-16451-01
3-209