Download beier USM-RC-2 Technical data

brixlelektronik
bc-12er – 12 channel receiver
...we got the solution
bc-20 plus 20 channel receiver
Please note that no infrared receiver should be connected during programming. For
programming an antenna or a cable connection must be used.
Funktion: Display [Feature: Display]
A 0.9“ display can be connected to output 12 to visualize different values. It will
display the operating voltage and the values measured by connected sensors.
Senderkanal
[Input device]
A-z
Defines the input device of the tranmitter that will change
the display content. (swap between measuring values
and hour meter). Momentary switch is recommended for
this option.
Screen content measuring values:
brixlcontrol
[status]
[mv1]
[mv2]
[mv3]
[mv4]
Akku:
12.0V (bc-20 plus only]
BEC :
5.04V
[status] can be either:
[Spannung EIN]
[betrieb]
[Empf.konfig]
[Funkabriss]
[geparkt]
Power supply on
Connected to transmitter
Receiver in programming mode
Connection lost, receiver in fail safe mode
Receiver in park mode
[mv1..4]
Measuring values as defined in [Funktion: Eingang Messen] Feature:
Measuring Input
Akku
voltage of power supply
BEC
voltage of BEC
Screen content hour meter:
brixlcontrol
[status]
Vers :
EinZ :
BSZG
BSZ
12417
12
0:27
0:23:15
[status] can be either:
[Spannung EIN]
[betrieb]
Power supply on
Connected to transmitter
23.06.14 Vxx417