Download Bunn JDF-2 Service manual

TROUBLESHOOTING (cont.)
PROBLEM
PROBABLE CAUSE
REMEDY
Water leak filling drip tray or around
dispense deck area
1. Initial fill/setup
Some expansion normal. May fill
drip tray during initial ice block
formation
2. Dispense deck
Inspect or replace fittings clamps,
o-rings, solenoids and quick disconnect fittings.
NOTE: Dispense deck area slopes
to drain tube that leads to the drip
tray.
3. Water pressure greater than
100psi
Install water pressure regulator and
reduce to 50 psi.
1. Bath tank overflow.
A) Check all internal water connections.
Water leaking beneath machine
B) Check internal plumbing connections.
2. Condensation from cabinet cooling coil.
Check for routing of condensation
tube to water bath.
Erratic spray during dispense
Dispense nozzle mixer missing or
broken
Replace mixer.
Dispense nozzle dripping water
Dispense solenoid.
Replace dispense deck solenoid.
23
39992 042007