Download Cisco ME 3800X Specifications

Chapter 2
Cisco ME 3800X and ME 3600X Switch Cisco IOS Commands
errdisable recovery
errdisable recovery
To configure the recover mechanism variables, use the errdisable recovery command in global
configuration mode. To return to the default setting, use the no form of this command.
errdisable recovery {cause {all | bpduguard | channel-misconfig | gbic-invalid | link-flap |
loopback | mac-limit | pagp-flap | oam-remote failure | port-mode failure |
ppoe-ia-rate-limit | storm-control | unicast-flood | | udld} | {interval interval}
no errdisable recovery {cause {all | bpduguard | channel-misconfig | gbic-invalid | link-flap |
loopback | mac-limit | pagp-flap | oam-remote failure | port-mode failure |
ppoe-ia-rate-limit | storm-control | unicast-flood | | udld} | {interval interval}
Note
Syntax Description
Although visible in the command-line help, the dhcp-rate-limit and psecure-violation keywords are
not supported.
cause
Enables the error-disabled mechanism to recover from a specific cause.
all
Enables the timer to recover from all error-disabled causes.
bpduguard
Enables the timer to recover from the bridge protocol data unit (BPDU) guard
error-disabled state.
channel-misconfig
Enables the timer to recover from the EtherChannel misconfiguration
error-disabled state.
gbic-invalid
Enables the timer to recover from an invalid Gigabit Interface Converter
(GBIC) module error-disabled state.
Note
This error refers to an invalid small form-factor pluggable (SFP)
error-disabled state.
link-flap
Enables the timer to recover from the link-flap error-disabled state.
loopback
Enables the timer to recover from a loopback error-disabled state.
mac-limit
Enables the timer to recover from the MAC limit disable state.
oam-remote failure
Enables the timer to recover from an Ethernet Operations, Administration,
and Maintenance (OAM) detected remote failure.
pagp-flap
Enables the timer to recover from the Port Aggregation Protocol (PAgP)-flap
error-disabled state.
port-mode failure
Enables the timer to recover from port mode change
ppoe-ia-rate-limit
Enables the timer to recover from Point-to-Point Protocol over Ethernet
(PPPoE) IA rate-limit.
udld
Enables the timer to recover from the UniDirectional Link Detection (UDLD)
error-disabled state.
unicast-flood
Enables the timer to recover from the unicast flood disable state.
Cisco ME 3800X and ME 3600X Switch Command Reference
2-66
OL-23401-02