Download Bremer VIVA Operating instructions

Up to version 2.05 only:
The displayed value is saved by
exiting or scrolling with one of
these keys.
Continued
on previous
page
Steam boiler
present:
NO
* old: Voltage: 230V_
Hot water:
measured
*new: E1-E2
locked/unlocked
Activate controller for hot water/steam boiler (NTC
temperature sensor, electrode etc.)
Switching options: YES/NO
NO = steam boiler controller off, steam boiler faults
are not displayed
Voltage selection (Locking of the boilers)
Depends on device model (refer to rating plate).
Switching options: 230 V / 400 V
Switching options Japan: 200 V / 3 x 200 V
Hot water metered or not metred
Default setting: metered
Steam dispensing switch start/stop function (adjustable from software version 2.00)
Steam outlet
not measured
Switching options: Metered = press steam key
to start, then press again to stop steam dispensing / Non−metered = keep steam key
pressed for as long as steam is required.
Default setting: non−metered
No.Total Brewing
Total.0000000000
Display of completed brewing cycles
This counter cannot be deleted.
Version:
3.02.044
Display of software version number
Service instructions bremer VIVA, issued 1997-07 Status: 2003-03
7-3