Download Epson PowerLite S3 Specifications

Epson PowerLite S3 Projector
Replacing Remote Control Batteries
Cleaning the Projector Case
When the batteries run out, follow the steps below to replace
them. The remote requires 2 AAA batteries.
Before you clean the projector case, turn off the projector and
unplug the power cord.
Note: Make sure you read the Safety Instructions in the User’s
Guide before handling the batteries.
❏ To remove dirt or dust, wipe the outside with a soft, dry,
lint-free cloth.
1. Push in the battery cover catch and lift up to remove the
battery cover.
❏ To remove stubborn dirt or stains, clean the case using a soft
cloth moistened with water and a neutral detergent. Dry it
using a separate cloth.
Caution: Do not use alcohol, benzene, thinner, wax, or other
chemicals. These can damage the case.
Cleaning the Air Filter
2. Insert the batteries.
If the air filter becomes clogged with dust, it can cause
overheating and damage the projector. Follow these steps to
clean the filter:
It is recommended that you clean the air filter at least once
every three months. Clean it more often if using the projector in
particularly dusty environments.
Check the positions of the (+) and (–) marks inside the
battery holder to ensure that the batteries are inserted the
correct way.
3. Replace the battery cover.
Note: If the air filter is broken or if a warning message reappears
after it has been cleaned, it should be replaced with a new air filter.
See the next section.
4. Press the battery compartment cover until it clicks into
place.
3/05
Epson PowerLite S3 Projector - 11