Download RAD Data comm ASMI-450 Specifications
Transcript
ASMi-450 Control from the Control Port 4.6 Control Terminal Operating Instructions Before using the control terminal, make sure the preparations listed in Section 4-3 were completed and all the relevant equipment has been turned on. Starting a Session - Single ASMi-450 When the terminal is used to control a single ASMi-450, always assign node address 0 to the ASMi-450. Use the following start-up sequence to connect to a ASMi-450 that has been assigned node number 0. 1. If you use the AUTO (Autobaud) mode, press the <CR> key three times. This allows the ASMi-450 to identify the terminal data rate. 2. Assuming that the ASMi-450 successfully identified the data rate of the control terminal, you will be notified if the ASMi-450 failed the power-up self-test: • If you see ASMi-450 SELFTEST FAILED, the ASMi-450 must be repaired before you can continue using it. • If ASMi-450 successfully passed the power-up self-test (ASMi-450 SELFTEST OK), it sends the following message: ASMI SUPERVISORY PORT ON LINE. TYPE “H” FOR HELP 3. By now, the ASMi-450 prompt should already be displayed on the terminal screen, after the ON-LINE announcement. If you see PASSWORD> this indicates that password protection is enabled. In this case, type the password: 'password'<CR> where 'password' stands for the current password (four to eight characters). For each password character typed by you, the terminal displays an asterisk *. The default password is ASMI. If your password is accepted, you will see the prompt ASMI>. 4. The ASMi-450 is now in session, under your control: • On your terminal, you will see the prompt: ASMI> • On the ASMi-450 front panel, you will see the message: TERMINAL ON LINE The front panel controls are disabled as long as the ASMi-450 is under remote control. 4-26 ASMi-450 Installation and Operation Manual