Download Baxi 748 Unit installation

INSTALLER GUIDE
15.2 Fitting the Chic fascia.
 Supplied with the fire is a controls heat baffle and
three edge clips. These must be fitted to the heat engine
before fitting the Chic fascia. Locate and secure the
baffle as in figure 38.
 Remove any protective film from the fascia.
 Locate the two lugs at the top of the fascia in the
slots in the convection box hood. Swing the bottom of
the fascia sides back against the convection box and
lower the fascia so that the lugs are fully seated in the
slots in the convection box hood (See figure 39).
 Secure the bottom of the fascia sides to the
convection box side brackets using the two screws
removed previously (See figure 39).
 Secure the top of the fascia to the convection box
Figure 38. Fitting the baffle
using the two screws removed
previously (See figure 40).
Figure 39. Fascia securing
Figure 40. Securing
the ‘Chic’ fascia to the
heat baffle
© Baxi Heating U.K. Limited 2009.
Page 36