Download DCS PHFS-DW User guide

Developers guidelines | AT commands
<bearer_type>:
<bearer_type>
Description
1–4
Specific bearer. For more information on bearer
types see <bearer_type> parameter definitions
under command AT*EIAC
<prefix>
Description
0–32
IPv4:
Value used to create a IPv4 subnet mask. Indicates
how many bits should be set to 1 in the mask.
0 indicates default route. A value of 24 will result in
the following subnet mask: 255.255.255.0
0–128
IPv6:
Value used to create a IPv6 subnet mask. Indicates
how many bits should be set to 1 in the mask.
0 indicates default route. A value of 24 will result in
the following subnet mask: FFFF:FF00::0
<ip_version>
Description
String format “IP”
Internet Protocol (IETF STD 5)
<prefix>:
<ip_version>:
String format “IPV6” Internet Protocol, version 6 (IETF RFC 2460)
<destination_address>:
<destination_
address>
Description
String of format
“a.b.c.d”
IPv4 address of the destination host.
An entry with a value of 0.0.0.0 is considered as the
default route
“x:x:x:x:x:x:x:x”
IPv6 address of the destination host.
Each “x” is the hexadecimal values for one of the
eight 16bit pieces of the address. An entry with a
value of :: is considered as the default route
<nexthop_address>:
<nexthop_address> Description
String of format
“a1.a2.a3.a4”
IPv4 address of the adjacent host or router to which
the packet should be sent next.
Not utilised for point-to-point connections
String of format
“x:x:x:x:x:x:x:x”
IPv6 address of the adjacent host or router to which
the packet should be sent next.
Each “x” is the hexadecimal values for one of the
eight 16bit pieces of the address.
Not utilised for point-to-point connections
270
June 2010