Download INTRODUCTION 0
Transcript
PEGASO 650 2.2.4. GENERAL TECHNICAL INFORMATION FRONT BRAKE BLEEDING The air, if any, present inside the hydraulic circuit will serve as "pad" by absorbing most of the pressure coming from the brake master cylinder and thus reducing the calliper efficiency during braking. If some air is present inside the circuit, the brake control is "spongy" and the braking efficiency is reduced. DANGER It is fundamental that air is bled off the hydraulic circuit after the brakes have been refitted and the braking system has been restored to its standard operating conditions, since it would be very dangerous for the vehicle and the rider not to do so. NOTE The following procedure applies to both front brake callipers. Bleed air with vehicle on flat ground. While bleeding the hydraulic circuit, top up reservoir with brake fluid as required. Make sure there is always some fluid in the reservoir throughout the process. • • • • • • Remove the bleed valve rubber cap. Insert one end of a transparent plastic tubing inside the front brake calliper bleed valve and the other end in a container for collection. Pull and quickly release the front brake lever a few times, then keep it pulled. Loosen the bleed valve by 1\4 of a turn so as the brake fluid flows in the container, this will remove any tension from the lever and help it travel fully home. Retighten the bleed valve before the lever is fully squeezed in. Repeat process until the fluid draining into the container is totally clear of air bubbles. NOTE While bleeding the hydraulic circuit, top up reservoir with brake fluid as required. Make sure there is always some fluid in the reservoir throughout the process. • • • Tighten the bleed valve and remove the tubing. Top up fluid inside tank. Refit the rubber cap. CHANGING THE PADS • Turn the pins and slide out both slit pins. 2 - 43