Download Vax K-002 User`s guide

CHAPTER 8
BUILDING AND UPDATING THE SYSTEM DISK
DIAGNOSTIC AREA
8.1
8.2
8.2.1
8.2.2
INTRODUCTION ....................................................................................................
BUILDING AND UPDATING THE DIAGNOSTIC AREA ...............................
Building and Updating the Diagnostic Area with the COpy Command ........
Building and Updating the Diagnostic Area with DUCT ................................
APPENDIX A
VAX-ll/730 INTERNAL PROCESSOR REGISTERS ....................................... A-I
APPENDIX B
MICRODIAGNOSTIC MONITOR COMMANDS ............................................... B-1
8-1
8-2
8-2
8-2
FIGURES
Figure No.
Title
Page
1-1
VAX-II Diagnostic System User Documentation .................................................... I-I
2-1
Power-Up Sequence of Events .................................................................................. 2-5
3-1
3-2
3-3
Cold Start of Either the Operating System or the Diagnostic Supervisor ............... 3-2
Warm Start of the Operating System ....................................................................... 3-7
Restart Parameter Block (RPB) ................................................................................ 3-8
TABLES
Table No.
Title
Page
1-1
VAX-I 1/730 Related Documentation ...................................................................... 1-2
2-1
2-2
2-3
2-4
2-5
2-7
CPU Halt Codes and Halt Conditions ...................................................................... 2-2
Functions of the Six-Position Keylock Switch .......................................................... 2-3
The Functions of the Three-Position AUTO/RESTART Switch ............................. 2-4
Functions of the Front Panel State Indicator Lights ................................................. 2-4
Control Characters for the Console I/O Mode ... .... ...... ... .... ...... ............. ..... .......... 2-10
EXAMINE and DEPOSIT Qualifiers and Definitions. .... ... .... ............ ......... ......... 2-12
The LOAD Qualifiers and Definitions ...... ..... ... ...... ... .... ........ ... ........ .... ...... ... ......... 2-15
3-1
Parameters Loaded into the General Registers at BOOT ........................................ 3-5
4-1
4-2
4-3
ENKBx Microdiagnostic Group Sections ................................................................. 4-1
ENKCx Microdiagnostic Group Sections ................................................................. 4-2
MICMON Error Code List (Hex) ............................................................................ 4-6
2-6
v