Download BPG werks REV060413 Operator`s manual

Track Replacement
Track replacement
If a track derails while riding use the
following procedure to replace it:
1. Remove the two front outside bogie
wheels (remember to pull straight on the
wheel so the bearing doesn’t jam on the
shaft)
2. shut the fuel off at the petcock and tip
the machine on its side.
3. Place track back in position ensuring it
is fully engaged in the drive sprocket and
in the correct position around the upper
and lower bogie wheels. Then push the
track over the front bogie wheels. Rotating
the track can help the track slide on more
easily. Replace the two front outer bogie
wheels making sure the bolt is tight.
4. The track may have come off due to
insufficient tension. Follow the track
tensioning instructions to increase the
track tension. Ensure the track tension is
equal on both sides. A track tending to
momentarily jam during turning is likely too
loose.
5. Right the vehicle, and turn the fuel
petcock back on before continuing to ride.
MAINTENANCE
Bogie wheels
Fuel Petcock
32