Download Bay Networks ATMSpeed Technical data
Transcript
Overview of the Model 5625HD Switch Module Features of the Model 5625HD Switch Module The Model 5625HD switch module offers the following features: • Wire-speed, port-to-port, packet transfer • Single-slot design to fit into the System 500xBH/BHC chassis • Autonegotiation of Ethernet 10/100 Mb/s speed • Autonegotiation of half- or full-duplex mode on dedicated switch ports • Layer 2 MAC-based switching • Local frame switching, module-to-module switching, backplane switching, and riser switching • 200 MHz RISC processor • 24 RJ-45 UTP network interface connectors • Front-panel LEDs to indicate module and port operational status • Port-based virtual LANs (VLANs) • Protocol-based VLANs Protocol-sensitive VLANs classifies packets based on protocol types. Most customers have multiple protocols per LAN segment, so a switch port needs to support multiple VLANs based on different protocol types. This feature allows you to separate data based on protocols and not on physical limitations. • IEEE 802.1Q Tag Recognition Support The Model 5625HD switch module supports recognition of VLAN tagged frames based on IEEE 802.1Q tags. Frames entering a Model 5625HD switch module port that contain an 802.1Q tag are mapped to a corresponding VLAN. Based on the final destination, the frame is sent as either an Ethernet-type frame or an 802.1Q VLAN tagged frame. VLAN membership is to be assigned by any combination of port with either tag or protocol. 206208-A • Support for IEEE 802.1d Spanning Tree • Content-addressable memory (CAM) support for 8192 entries • Port steering/port mirroring • Input and output filtering supported by switching software • Hardware support for IP multicast 1-3