Download Cisco AS5300 - Universal Access Server Installation guide
Transcript
Overview Overview The VoIP capability enables a Cisco access server to carry live voice traffic (for example, telephone calls and faxes) over an IP network. The VoIP card is available as a spare or a factory-installed card within the chassis. Use this document if you are: • • Installing or upgrading 6 session voice modules — Part Number AS53-6VOX (DSPM 542) Installing 12 session voice modules — Part Number AS53-VOXD (DSPM 549) The VoIP card contains multiple digital signal processor (DSP) modules. It uses the Cisco AS5300’s interface and local-area network (LAN) or wide-area network (WAN) routing capabilities to provide up to 48/60 channels per Cisco AS5300 universal access server using the AS53-6VOX voice modules, and up to 96/120 channels per Cisco AS5300 universal access server using the AS53-VOXD voice modules. If you purchased a chassis with this card already installed, go directly to the section “Preparing to Configure the Software,” page 17. The VoIP card has two primary applications. The first application (see Figure 1) provides a central-site telephony termination facility for VoIP traffic from multiple voice-equipped Cisco AS5300 remote office facilities. Figure 1 VoIP Card as Central Site 729 555-1001 729 555-1002 408 555-1001 729 555-1000 729 555-1003 T1 ISDN PRI Voice port 0:D 1:D T1 ISDN PRI WAN 10.1.1.1 Cisco AS5300 Access Server 1 IP cloud Voice port 0:D WAN 10.1.1.2 Cisco AS5300 Access Server 2 408 555-1003 2 Updates to Cisco AS5300 Universal Access Server Module Installation and Software Configuration Guides 18198 408 555-1002