Download Seagull Models PC-6 Specifications

Jumper 25
 9) Slide one 60mm diameter wheel onto
each axle and push them up against the wheel
collars. Slide the remaining wheel collars with
3mm x 6mm set screws onto the axles. Push
them up against the wheels and tighten the set
screws. The wheels should spin free and not
bind in any way. If they do bind, loosen the
set screws in the outer wheel collars and move
the collars out a small amount. Retighten the
set screws.
Instruction Manual
Installing steering arm as follow.
Adjust the nose gear steering arm until the
arm is parallel with the fire wall.
NOSE GEAR INSTALLATION
PARTS REQUIRED
q
q
q
q
{1}
{1}
{1}
{1}
Nose gear.
Steering arm.
Connector.
Wheel.
Pushrod wire
INSTALLING THE MAIN GEAR WHEELS
Slide one 60mm diameter wheel onto each
axle and push them up against the wheel
collars. Slide the remaining wheel collars with
3mm x 6mm set screws onto the axles. Push
them up against the wheels and tighten the set
screws. The wheels should spin free and not
bind in any way. If they do bind, loosen the
set screws in the outer wheel collars and move
the collars out a small amount. Retighten the
set screws.
TOOLS REQUIRED
7