Download D-Link 900W - DCS Network Camera Specifications

DCS-900 Configuration (continued)
Advanced > System
Username/E-mail-
Enter your username or e-mail used to connect to the
DDNS server.
Password/Key-
Enter your password or key used to connect to the
DDNS server.
LED Control:
The LED control allows you to set up the LED illumination as desired. This feature
provides flexibility for surveillance activity.
There are three options as follows:
ƒ Normal
Power -LED indicator is steady ON.
LAN- When LAN activity is present, the LED indicator will flash randomly
ON.
ƒ OFF
Power - LED indicator is off.
LAN – LED indicator is off.
ƒ Dummy
Power - LED indicator is steady ON.
LAN - LED indicator is ON flashing randomly.
The default setting for the LED control is Normal. When you have configured the LED
control the correct illumination will be applied after 1 minute.
Note: The three LED options allow the Administrator to customize the LEDs for
discreet camera operation in surveillance scenarios. In Normal Mode, the LED
indicator functions normally. Under Off Mode, the LED indicators are both OFF during
active monitoring. In Dummy Mode, the LEDs are active and monitoring is either
active or inactive.
Loading ActiveX From:
This field is used to specify the location of Xplug Control (ActiveX) plug-in program. Enter
the information as required in .ocx format, for example: http://www.<your company>.com/
xplug.ocx where <your company> must be replaced with your company’s DNS server.
Instructions for installing ActiveX from the driver CD is included in this manual. Please
refer to the Appendix.
21