Download SeaDoo GSX Technical data

Section 01 ENGINE
Subsection 03 (BOTTOM END)
6, Starter Drive Assembly
10, Reed Valve
Loosen 2 Allen screws no. 7 retaining starter
drive cover no. 8.
Remove both carburetor flanges.
F06D0JA
1
1. Carburetor flange
F06D1CA
2
1
Remove reed valves from crankcase.
1. Cover
2. Allen screw
11, Crankcase
Remove starter drive cover no. 8 and spring
no. 9.
Remove starter drive assembly no. 6.
Place engine upright on crankcase magneto side.
F06D1DA
1. Starter drive assembly
F06D1QA
1
Loosen crankcase bolts no. 12 and no. 13 starting from center to the outside.
Put engine back on a trestle and remove the upper crankcase half.
Insert a pry bar between crankcase lugs to separate halves. Be careful not to damage precision
machined surfaces.
01-03-3
www.SeaDooManuals.net