Download INSERT HEAD Module - Neopost Technologies Ltd

Technical Tips - INSERT HEAD Module
A-18A. Insertion Crashes Jan 2007 Updates
There have been a number of mechanical and software changes in the machine to improve
the general insertion reliability and they include the following:1) Viewing holes have been added to the sides of the envelope feed to view finger entry
into envelope and insertion - Implemented Set 06
2) New profile adjustable middle fingers A7367A (Ops side) and A7368A (Drive side) –
implemented after Sept 06. These fingers help to open the envelope throat to improve general
insertion reliability. The fingers are also engineer adjustable so that they can be lengthened
for customers running envelopes with a deep throat profile. In very extreme cases (out of
Specification envelopes) where the envelope stop position has to be run very fwd (from the
notch) to allow the external fingers to enter the envelope then it may be worth fitting A3325A
(fingers with greater extension than above).
2) Stainless Steel outer fingers B9203A (Ops side) and B9202A (drive side) for
improved wear – implemented Jan 07.
4) Fingers catching in the envelope feed tray roller cutouts – this can be prevented by the
addition of a plastic guide tape that reduces the gap between the roller and the cutouts –
Implemented Oct 06. Part numbers:
G6210A (LH)
G6211A (RH)
5) Envelope deskew times altered from standard;
Low was 20ms, is now 30ms.
Medium was 30ms, is now 50ms.
High was 40ms, is now 100ms.
Released in firmware versions V4-1-0-0 onwards or PD4-1-0-0
12/02/07
Page 1-28