Download INSERT HEAD Module - Neopost Technologies Ltd

Technical Tips - INSERT HEAD Module
A-36A. Flap catches on the Envelope Opener – Jan 2007 Update
Envelope opening issues with particular curly flaps – a modified extrusion is now available
and can be fitted to overcome this problem (assembly number is A7380A which is fitted with
envelope opener curled flap C7419A).
A-37. Upgrading MaxiMailer to MaxiMailer Plus
For upgrading a MaxiMailer (GUI version) to MaxiMailer Plus (PC version) - please refer to
the Fitting Instructions K4039A.
A-38. Error 57 (Version 3 and upwards)- 5v supply low
This error can cause other faults like for e.g. code 202 (clear collate pocket) - this implies a
possible short that is taking the supply down. Corrective actions check the relevant sensors
(collate pocket, collate pocket entry and input conveyor) either using am4go or using the
engineer function in the GUI. Then check ribbon cables and splitter boards associated with
the above sensors. There have been some instances where the pawls catching on the ribbon
cable can cause this problem - check this by removing the pocket backstop Assembly
A7058A (pg 4a-23, Service Manual).
A-39. Plug and Play
This is a new feature with the latest firmware - at power-up the machine checks for the
number of modules fitted, type and calibration information.
This is the detected machine configuration. The detected machine configuration is then
compared with the programmed machine configuration. If there is a miss-match, the user is
given the option to accept the detected configuration, accept the current programmed
configuration, or go to the engineer setup screen and edit the current configuration.
The key benefits of Plug and Play are:
if a module is added, removed or changed to a different type, the new configuration will be
detected and can be readily updated
if a board is changed on the head or module, the new board will be detected and settings can
be readily restored from the INI file
if a new PC is fitted, the configuration can be 'read' from the machine
IMPORTANT : DIP switches must be correctly set to the module address on power-up!!
If new CPU board fitted on GUI – Head, then accept settings.
If new CPU board fitted on GUI – Module, then edit and configure.
A-40. Rubber Roller Restorer (E0483A)
A new cleaning agent is available for cleaning ALL rollers on the MaxiMailer and MaxiMailer
Plus. This is water based cleaner, which is aggressive enough to remove toner from the
rollers.
12/02/07
Page 1-50