Transcript
6822-167-B Clothes Closet A1 4 ea ©2009 Whitmor B 4 ea E 1 ea C 4 ea F 1 ea Horizontal frame tube Clothes rod Corner support Horizontal Male frame tube A2 2 ea G 1 ea Cover Male clothes rod This product's intended use is for storing clothes. D 6 ea Center support Assembly Time: Less than 1 hour. Tools Needed: No tools required. Vertical frame tube Note: For easier assembly, unzip cover before installing. G Note: All metal parts must be inserted firmly and completely into the plastic parts. Note: Closet rods (E & F) are wider in diameter than frame tubes (B & C) and are inserted into the larger lower center holes on (A1 & A2). D A1 A1 C C A2 A2 C B B G B A1 E F C B A1 STEP 1. To assemble the lower frame, insert two frame tubes (B) into one corner support (A1). Insert two male frame tubes (C) into center support (A2) where frame tubes intersect. Place another corner support (A1) onto the end. STEP 2. Insert six vertical frame tubes (D) into lower frame. Do not assemble the vertical frame tube sections together yet. Unzip zipper on cover (G) and carefully fit holes in bottom of cover over the vertical frame tubes. Slide cover down and carefully lay the cover back. STEP 3. To assemble top of frame, insert two frame tubes (B) and the clothes rod (E) into one corner support (A1). Insert center support (A2) onto the tubes. Insert two male frame tubes (C) and the male clothes rod (F) into center support where frame tubes intersect. Place another corner support (A1) onto the end. Note: Although your clothes closet can be assembled by one person, it is recommended that two people install the cover. D D Part A1 A2 B C D E F G STEP 4. Complete assembly by unfolding the vertical frame tubes (D) and placing the two sections together. Place assembled upper section (assembled in step 3) onto end of frame tubes. STEP 5. Lift cover up over the top of the frame, carefully fitting the corners of the cover over the top corners of the frame. Slide the bottom of the cover downwards evenly to the base of the frame. Reference F6947 F6953 F6954 F6955 F6956 F6957 F6958 F6959 MADE IN CHINA 8680 Swinnea Road • Suite 103 • Southaven, MS • 38671 NEED HELP? For help with assembly, or if you are missing a part, please call Whitmor’s Customer Service Department, 1-888-944-8667 between 8 a.m. and 4:30 p.m. (Central Standard Time) Monday through Friday. Or email: [email protected] Printed in China