Download Rolls PB23 User's Manual
Transcript
This product is warranted to the original consumer purchaser to be free from defects in materials and workmanship under normal installation, use and service for a period of one (1) year from the date of purchase as shown on the purchaser’s receipt. The obligation of Rolls Corporation under this warranty shall be limited to repair or replacement (at our option), during the warranty period of any part which proves defective in material or workmanship under normal installation, use and service, provided the product is returned to Rolls Corporation, TRANSPORTATION CHARGES PREPAID. Products returned to us or to an authorized Service Center must be accompanied by a copy of the purchase receipt. In the absence of such purchase receipt, the warranty period shall be one (1) year from the date of manufacture. This warranty shall be invalid if the product is damaged as a result of defacement, misuse, abuse, neglect, accident, destruction or alteration of the serial number, improper electrical voltages or currents, repair, alteration or maintenance by any person or party other than our own service facility or an authorized Service Center, or any use violative of instructions furnished by us. This one-year warranty is in lieu of all expressed warranties, obligations or liabilities. ANY IMPLIED WARRANTIES, OBLIGATIONS, OR LIABILITIES, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, SHALL BE LIMITED IN DURATION TO THE ONE YEAR DURATION OF THIS WRITTEN LIMITED WARRANTY. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. IN NO EVENT SHALL WE BE LIABLE FOR ANY SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESSED OR IMPLIED, WHATSOEVER. Some states do not allow the exclusion or limitation of special, incidental or consequential damages so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. Owners Manual 12 VOLT 48 VOLT PHANTOM VOLTAGE PB23 PHANTOM POWER ADAPTER 12VDC PWR LOOP MIC INPUT MIC OUTPUT PHANTOM POWER ADAPTER PB23 LIMITED WARRANTY PB23 Phantom Power Adapter • Powers a condenser microphone requiring phantom power • 12 or 48 Volts available • AC adapter included • High frequency switching power supply to elliminate noise The PB23 is for powering a phantom powered microphone with either 12 or 48 VDC. The unit uses a 100kHz switching power supply to elliminate noise generated by common power supplies. The PB23 has pull-down resistors so it will work with any mixer. 2 DC jacks have been included so several units may be operated with one power supply. Rolls Corporation Salt Lake City, UT 9/95 INTRODUCTION Thank you for purchasing the PB23 Phantom Power Adapter, the unit is designed to provide years of lasting value and usefulness. The unit powers a condenser microphone that is designed for phantom powering. Phantom power microphones provide much greater dynamic range, lower noise and better sound quality. Most microphones will operate at full performance with 12 volts DC, however some mics require 48 volts which was the old tube mic standard. The PB23 features selectable voltage levels. AC ADAPTER MIC OUTPUT MIC INPUT 12VDC PWR LOOP MIXER PHANTOM POWER ADAPTER OPERATION Switch the PHANTOM VOLTAGE to the appropriate setting. Connect a condenser microphone to the input connector(s) and connect the output(s) to a mixer or other audio input device. Apply power to the unit by connecting the enclosed adapter to an AC outlet and to the 12VDC Power Loop. The LED on the front of the unit will light. The two DC input jacks are provided in order to use one power supply to power more than one unit. The units provide no audio gain as they are not microphone preamps. PB23 PHANTOM VOLTAGE 12 VOLT 48 VOLT C4 2 J1 47U 2 47U C3 3 XLR F PC 3 1 XLR M PC 1 R4 R5 J2 6.8K 6.8K C10 503 U1A 1 MIC OUTPUT MIC INPUT 12VDC PWR LOOP U1F 13 R3 12 4069 10K U1E 11 R1 22K 10 4069 3 5 U1B U1C U1D 9 C10 4069 2 4069 4 C7 .047 C8 .047 2 48V 4069 6 C9 1 SW1A DPDT 3 12V .047 4069 8 120PF D6 D5 D3 C5 1U D7 D4 D2 C11 1U C6 1U 1N4148 1N4148 1N4148 J3 PHANTOM POWER ADAPTER 1 2 3 1 U2 7812 I O G C1 JAPDC D1 2 3 1N4148 1N4148 1N4148 C2 1 UF 1000UF 1N4001 ROLLS CORPORATION Title PB23 PB23 PHANTOM BOX Size Date: PHANTOM VOLTAGE 12 VOLT 48 VOLT Document Number A SPECIFICATIONS Phantom Voltage: Jacks: Control: Power Input Size: Weight: REV PB23.SCH September 4, 1995 Sheet 12V or 48V selectable Male and Female XLR jacks, 2: 5mm DC input jacks 12/48 volt selector switch 14 - 18 VCD (adapter included) 3" x 2.5" x 1.25" 1 lb (.45 Kg) of