Download Sharp MX-M363U Setup guide

Transcript
SELECTING A SPECIAL MODE
The procedure for selecting a special mode for fax is explained below.
The settings that must be selected vary for each special mode, however, the general procedure is the same. The
procedure for erasing shadows at the edges of the image when sending a fax is explained below as an example.
1
The side to be scanned must be face up!
Place the originals.
When using the document glass, place the
original with the side to be scanned face down.
Ready to send.
Fax
Mode Switch
Scan
Speaker
Send
A4
Resend
2
(1) Touch the [Special Modes] key.
Address Book
Auto
Image
Settings
Sub Address
Memory TX
Special Modes
Direct TX
File
(1)
Auto Reception
Fax Memory:100%
Quick File
Fax
Special Modes
(2) Touch the [Erase] key.
OK
The erase settings will be configured to
erase a width of 15 mm around the edges
of the original.
1/3
Program
Dual Page
Scan
Erase
(2)
Timer
Select settings in the touch panel.
2in1
Card Shot
(3) Set the erasure width to 15 mm with
the
keys.
Erase
Edge
Erase
The erase area is set to "Edge Erase" by
default.
To select "Centre Erase", "Edge+Centre
Erase", or "Side Erase", touch the
appropriate key.
OK
Special Modes
Cancel
Edge+Centre
Erase
15
OK
(4)
Edge
(0~20)
mm
(4) Touch the [OK] key.
(3)
3
Enter the fax number of the receiving
fax machine and press the [START]
key.
Cancel scanning
67