Download Bosch 4412 User guide

Transcript
Security System User’s Guide
Command Center LED Descriptions
LED
State
Status
On
Description
No System Troubles.
Slow Flash
AC failure, system trouble or keypad has been moved
away from its assigned area.
Fast Flash
Command Center in Command Mode System test has
been initiated.
Cmd
Off
User logged off and no command is active.
Fast Flash
Waiting for passcode entry.
On
Exit Delay timer is active or a command is in progress.
Off
Panel disarmed or armed Part On.
Slow Flash
Panel armed All On with No Delay.
All
Part
On
Panel armed All On with Entry/Exit Delay.
Off
Panel disarmed or armed All On.
Slow Flash
Panel armed Part On/Part 2 On with No Delay.
Panel armed Part On/Part 2 On with Entry/Exit Delay.
On
Commands
Commands allow you to carry out various tasks (for example, add or delete
passcodes, set the date and time or test the system, etc.). Each command
is detailed throughout this user guide.
Commands will be written like the following: [Cmd] + [6] + [3]. To enter
this command, you would first press the [Cmd] key, followed by the [6] key
and then the [3] key.
System Events
Your system responds to four types of alarm events. If more than one
event occurs, your system sorts them into one of four groups: Fire Alarms
(highest priority), Burglary Alarms, Fire Troubles and Non-Fire Troubles
(lowest priority). Events that are grouped as highest priority are always
sent to the Central Station first.
46840C
LED Command Center User’s Guide
Page 10
Copyright © 2002 Radionics