Download Sharp VL-E78E Specifications

Preparation
Use the optional VR33CH
car battery adaptor/battery
charger (or the VR-41 OCA car battery adaptor) when
you want to power the VIEWCAM from the cigarette
lighter socket of your car.
Perform steps 1 through 3 under “Powering
VIEWCAM from an AC Outlet” (page 10).
l
l
the
l
See the VR-33CH (or VR-410CA) operation
manual for details.
The battery pack can be recharged by using the
VR-33CH in basically the same manner as the
supplied AC adaptor/battery
charger (see page 9).
The VR-41OCA cannot be used to recharge battery
packs.
Plug the DC cable into the DC OUT jack on the
VR-33CH (or VR-41 OCA).
Use in only DC 12 V or 24 V negative ground
system cars. Positive-ground
car batteries
CANNOT BE USED. Check your car-operation
manual or consult a local car dealer.
Use the VR-33CH (or VR-410CA) only when the
car is idling or being driven. Otherwise, the car’s
battery will be drained.
Charge only SHARP model BT-N1 or BT-Nil,
BT-H11 battery packs. Other types of batteries may
burst, causing personal injury and damage.
Before starting the car engine, the VR-33CH (or
VR-41 OCA) must be unplugged from the cigarette
lighter socket.
Before removing either the DC plug or the cigarette
lighter plug, the VIEWCAM’s Power switch should
be set to OFF.
Next, start the car engine and leave it idling. Then
inset-t the plug into the cigarette lighter socket. (The
POWER indicator on the VR-33CH will light up.)
i When powering from
1 your car’s cigarette lighter
battery charger
VR-33CH (optional
I
or
I
I
I
I
I
I
I
I
I
I--__----_---__--__-_-_-------
;
I
I
I_
I
I
I
I
I
I
I
DC OUT jack
i
I
I
I
Car battery adaptor
i
I
I
I
J