Download Comtech EF Data SDM-100A Specifications

Operation
SDM-100A Satellite Modem
SDM-100 "TYPE"
VER: 14.7.4
FUNCTION SELECT
MONITOR
RAW BER
CORRECTED BER
CURRENT RAW BER
NO DATA (if carrier not locked)
CURRENT CORRECTED BER
NO DATA (if carrier not locked)
Low limit: based on performance.
High limit: based on data/code rate.
Low limit: based on performance.
High limit: 1.0 E-12.
RECEIVE SIGNAL
EB/N0
CURRENT Eb/N0
NO DATA (if carrier not locked)
Low limit: based on data rate.
High limit: 16.0 dB.
CURRENT RECEIVE
LEVEL
( 25.0 to -60.0 dBm)
Key:
ACCESS TO
SUBMENU
CONDITIONAL OR
OPTION-DEPENDENT
Parameter Information
Figure 3-19. Monitor (Type 1 Operation)
3.2.2.2 Monitor: Type 1 Operation
When the Monitor level is entered, press [←] or [→] to select the desired monitor function.
Each monitor function is displayed in real time as long as it is selected.
RAW BER
CORRECTED BER
Eb/N0
RECEIVE SIGNAL
Raw bit error rate
Corrected bit error rate
Energy (bit)/noise ratio
Receive signal level
Range: <m.m E-e to >m.m E-e
Range: <m.m E-e to >m.m E-e
Range: <mm.m to >mm.m
Range: <-mm.m to >-mm.m
(See Note)
(See Note)
(See Note)
(See Note)
Note: When the decoder loses lock, no data is available, and is so indicated. If data is
over or under range, “<” or “>” will be indicated.
3–60
Rev. 0