Download Sima VS-HD14 Specifications

SECTION
PAINT
COMPLY
SPECIFICATION DETAIL
YES
NO
The fenders shall be a minimum of 3/16” steel “diamond” floor plate for
slip resistance and rigid enough to be used as a work platform.
Protective tail light pockets will be an integral part of each fender.
All pieces exposed shall be properly coated.
All raw materials used in the manufacturing process shall be new and
unused and properly coated with an industrial equipment primer and
industrial equipment paint coating.
Keizer-Morris International yellow will be the primary coating color.
RUST PREVENTIVE ABRASION RESISTANT COATING
YES
Asphalt Patcher underside and frame must be coated in Megaflex
Preventive Abrasion Resistant Coating.
Coating must be a one part acrylic base self-priming, thixotropic
semi-paste coating that contains at least 36% highly elastic in waterdispersed polymers.
Coating must be fluid applied and cure to form a seamless rubber antirust and waterproof coating that can be applied over clean dry
surfaces of other tight coatings. V.O.C. (Volatile Organic Compound)
shall be 0.01 or less.
Coating must be 100% waterproof
Coating must be 100% ultra-violet resistant so as not to break down
as a result of long-term exposure to sunlight
Coating must be capable of 200% elongation so as to completely
prevent cracking due to expansion and contraction as well as dimpling
resulting from impacts
Coating must afford excellent chemical resistance to acids alkalis,
salts and fuels. Coating must be self-extinguishing
Coating must dry to a smooth texture.
Coating dry film thickness shall be 14 mil.
Coatings offered shall have been tested in the following areas
Results shall be in the minimum acceptable to Suffolk County
Test documentation must be available to Suffolk County upon request
Specific Gravity not less than 1.28
Solids by Weight Not less than 67%
Solids by Volume Not less than 57% Spread Rate
400 grams p/sq. meter, per coat at not less than 13 mils.
Dry Time: 30 minutes at 70 degrees F. and 50% relative humidity.
NO