Download Data Acquisition: User`s Manual

Transcript
Elekta Neuromag
5.3
5.4
5.5
5.6
5.7
DATA ACQUISITION
5.2.1 Normal HPI acquisition.................................................... 38
5.2.2 HPI fitting......................................................................... 38
5.2.3 Continuous HPI ............................................................... 39
Raw data display.......................................................................... 41
5.3.1 Controls ........................................................................... 42
5.3.2 Channel selections .......................................................... 43
5.3.3 Scales ............................................................................. 44
5.3.4 XY display ....................................................................... 45
On-line averaging......................................................................... 46
5.4.1 Messages ........................................................................ 46
5.4.2 Adjusting on-line averaging ............................................. 46
5.4.3 Marking channels as “bad” .............................................. 46
5.4.4 On-line average display .................................................. 47
5.4.5 Select displayed categories ............................................ 47
Raw data recording...................................................................... 47
EEG impedance measurements .................................................. 48
Stopping the acquisition............................................................... 50
6 Saving data ......................................................................... 51
6.1
6.2
6.3
6.4
Data volumes ............................................................................... 51
Saving averages and raw data .................................................... 51
The saving dialog......................................................................... 52
Rescuing data after a crash ......................................................... 52
7 Restarting the software ..................................................... 54
7.1 When to restart ............................................................................ 54
7.2 Restarting procedure ................................................................... 54
8 Using signal space projection .......................................... 56
8.1
8.2
8.3
8.4
Background.................................................................................. 56
Setting up for on-line SSP............................................................ 56
SSP and the on-line averager...................................................... 57
Creating SSP operators ............................................................... 57
8.4.1 Pre-requisites .................................................................. 57
8.4.2 Procedure........................................................................ 57
9 Phantom measurement...................................................... 60
9.1
9.2
9.3
9.4
9.5
Introduction .................................................................................. 60
Phantom control tool user interface ............................................. 60
Procedure for system verification................................................. 61
Procedure for probe verification................................................... 62
Customizing the phantom measurement ..................................... 62
A Software Structure ............................................................ 63
B Changes from previous release ....................................... 64
NM23065A-B