Download DL8000 Preset Controller Instruction Manual

Transcript
DL8000 Preset Instruction Manual
little, and then carefully pry the right ejector. You will feel and hear
the CPU as it detaches from the backplane.
6. Remove the CPU module carefully. Make sure not to pull on any
cables attached to the CPU module.
2.3.4 Installing the CPU Module
16B
To install the CPU module:
Caution
Failure to exercise proper electrostatic discharge precautions (such as
wearing a grounded wrist strap) may reset the processor or damage
electronic components, resulting in interrupted operations.
When working on units located in a hazardous area (where explosive
gases may be present), make sure the area is in a non-hazardous state
before performing procedures. Performing these procedures in a
hazardous area could result in personal injury or property damage.
1. Slide the CPU module into the slot.
2. Press the CPU firmly into the slot, ensuring the ejector clips rest on
the module rail guides. The connectors at the back of the CPU
module fit securely into the connectors on the backplane.
3. Place the CPU faceplate on the CPU.
4. Tighten the two captive screws on the faceplate of the CPU module
firmly.
5. Replace the wire channel cover.
6. Return power to the DL8000.
2.4 License Keys
4B
License keys with valid license codes grant access to applications or, in
some cases, allow optional firmware functionality to execute. In some
situations, a license key may also be required before you can run the
application. Examples of licensed applications include DS800
Development Suite software, meter run calculations, and various User C
programs (such as LiquidCalcs in this application). You can then
configure these applications using ROCLINK 800 or the DS800
Development Suite software.
The term “license key” refers to the physical piece of hardware (see
Figure 2-7 and Figure 2-8) that can contain up to seven different
licenses. Each DL8000 can have none, one, or two installed license
keys. If you remove a license key after enabling an application, the
firmware disables the task from running. This prevents unauthorized
execution of protected applications in a DL8000.
Revised Mar-12
Installation and Use
2-11