1
Download DL8000 Preset Controller Instruction Manual
Transcript
DL8000 Preset Instruction Manual powering low-power analog transmitters, while another module in the same DL8000 controller can provide +24 Volts dc for powering conventional 4 to 20 mA transmitters. See Figure 3-5. +T 12 / 24 V dc Jumper Precision Resistor Figure 3-4. AI-12 Jumper J4 (Shown Set to +12V) + OUT SIGNAL COM + - 1-5 VOLT DEVICE EXTERNALLY POWERED 1-5 VOLT DEVICE EXTERNALLY POWERED IN + CURRENT LOOP DEVICE 4-20mA ROC809 POWERED DOC0506A Figure 3-5. Analog Input Module Field Wiring On the AI-16 module, you use jumper J3 to configure the AI (+T) as 12 or 24 Volts dc. Additionally, two DIP switches provide scaling control (see Figure 3-6). 3-8 Modules Revised Mar-12
