Download RIPCON CONFIGURATION SOFTWARE USER MANUAL

Transcript
®
2.3 Chart “Transfer” (“Transfer“)
With the help of this menu item all settings are transmitted to the ripple control receiver via the serial interface.
Please choose the COM port (RS 232 PC serial port) via which the TS-72 programming adapter is connected to the PC. It will
automatically detect the COM port displayed that provides the PC.
Now connect the programming adapter with the ripple control receiver. The red LED in the TS-71 must begin flashing every second,
which means that TS-71 is ready to receive data from a PC. Otherwise, TS-71 is not ready to receive any data.
In standby mode TS-71 to receive data you can then choose from the menu "Transmition RSE" ("An RSE übertragen").
If the data transmission was successful this will be displayed on the screen.
The TS-72 is now ready for use.
Via this menu item "Transmition RSE" ("An RSE übertragen"), the data can be read from the ripple control receiver again.
The screen also displays the message even if the data transfer was unsuccessful.
In this case must be checked again whether all cables are connected properly and the correct COM port has been selected.
Please also make sure that the COM port is not in use by another Windows application.
Your partner for measuring the energy
DIN RAIL MOUNTED kWh METERS
RE/CONDITIONED kWh METER
PRE/PAZMENT kWh METERS
CREDIT CARDS kWh METERS
GSM OPERATED kWh METERS
SPECIAL kWh METERS
OTHERS FOR THE MEASUREMENT OF EL. ENERGY
CURRENT TRANSFORMERS
MEASURING POWER IN HARBORS AND ANCHORAGE SHIP
(MARINAS)
MEASURING POWER IN THE CAMP, IN TRADE FAIR,
EXHIBITION, BUSINESS, COMMERCIAL AND
ADMINISTRATIVE CENTERS
ENERGY MANAGEMENT SYSTEMS
(M-Bus, PLC, GSM, RS-485, EIB, INSTA-BUS)
Our advice is for You with pleasure
© KRALgroup
9010S.06
 Meinlinova 309/8 CZ-190 16 Praha 9 - Koloděje
 +420 602 360 502
 +420 602 360 501
 +420 281 970 988
http://www.kralgroup.cz
 [email protected][email protected]