Download IMITATOR User Manual - LSV
Transcript
Imitator 2.2 User Manual R Q S ξ Q π π π‘β Figure 5: SR latch (left) and environment (right) 5 Example: SR-latch We consider a SR-latch described in, e.g., [13], and depicted on Fig. 5 left. The possible conο¬gurations of the latch are the following ones: π 0 0 1 1 π 0 1 0 1 π latch 0 1 0 π latch 1 0 0 We consider an initial conο¬guration with π = π = 1 and π = π = 0. As depicted in Fig. 5, the signal π ο¬rst goes down. Then, the signal π goes down after a time π‘β . We consider that the gate Nor 1 (resp. Nor 2 ) has a punctual parametric delay πΏ1 (resp. πΏ2 ). Moreover, the parameter π‘β corresponds to the time duration between the fall of π and the fall of π . 5.1 Parametric Reachability Analysis We ο¬rst perform a reachability analysis. The launch command for Imitator is the following one: IMITATOR SRlatch.imi -mode reachability Considering this environment, the trace set of this system is given in Fig. 6, where the states ππ , π = 0, . . . , 6 correspond to the following values for each signal: State π0 π1 π2 π3 π4 π5 π6 5.2 π 1 0 0 0 0 0 0 π 1 1 0 1 0 0 0 π 0 0 0 0 0 1 0 π 0 0 0 1 1 0 1 Behavioral Cartography Algorithm Using Imitator, we now perform a behavioral cartography of this system. We consider the following rectangle π0 for the parameters: 18