1
Download Hardware Operation Guide
Transcript
2. 3 Replacing Roll Media NOTE (1) A paper mis-feed tends to occur just before out of a roll paper. (2) A tracing roll paper is recommended to be loaded to Roll Deck 1 (front). Reference This section describes how to install a roll media to Roll Deck 1. The same procedure is applied to Roll Deck 2, unless otherwise noted. 1. Pull the blue lever (1) to unlock the Roll Deck. Draw out the Roll Deck. 1 2. Holding both Flanges (2), lift and remove a roll media or an empty roll core (3). 2 3 3 2 2-5 Chapter 2 Basic Operation
