Download Model UP750 Program Controller User`s Manual for Single

<Toc>
4-3
<4. Operations>
● Heating/Cooling OUT Display
On the Setpoint display (LCD), the controller displays the current target setpoint (SP), the
PID number (PID) being used, the program pattern number (PTNO), the segment number
(SEGNO) for which operation is in progress, the number of segments included in the
selected program pattern, and the heating-side (HEAT) and cooling-side (COOL) control
output values.
● Deviation Trend Display
On the Setpoint display (LCD), the controller displays the deviation trend.
● Pattern Display
On the Setpoint display (LCD), the controller displays the selected program pattern.
● Event Display
On the Setpoint display (LCD), the controller displays the event number for which an event
has occurred.
SP:
25.0°C
PTNO: 1
TM=0h20
SEGNO: 1/ 3
RCY: 0/ 0
DISP
SP=
25.0 / 80.0°C
SEGNO= 1/ 3
CooL
DV-trend /scan=
Target SP display
For monitoring only.
key
SP=
25.0°C
PID: 1
C= 40.0%
H= 0.0%
DISP
For monitoring only.
However, allows the setpoint and segment time
to be changed during hold mode operation
(soak segment).
key
PTNO= 1
DISP
SP display
Heating/Cooling OUT
display
Allows the control output value to be changed
during manual operation.
key
20sec
+
0
Deviation Trend display
For monitoring only.
Pattern display
For monitoring only.
Event display
For monitoring only.
-
DISP
key
PTN
1
SEG
1
DISP
key
TME 1
PVE
ALM
21
3
DISP
key
IM 05E01B02-41E
1st Edition : May 31,2000-00