Download LabelWriter SE300 User Manual

FF
Form Feed
DESCRIPTION
Prints the contents of the text buffer and advances the print
media. The distance the media will advance depends on two
factors: the feed distance specified by the GS L command and the
presence of a punch hole. The LabelWriter will advance until a
punch hole is detected or until the feed distance (specified by the
GS L command) has been reached.
When the printer is powered on, the feed distance stored in
NVRAM is used as the default distance; the factory default is 7½
inches. A new feed distance specified by the GS L command will
override the NVRAM setting until the printer is either powered
down or a reset command is issued (by the ESC @ or ESC *
command).
The FF and ESC E commands are the same and produce the same
result.
EXPRESSION
ASCII
Decimal
Hex
FF
12
0C
PARAMETERS
None
EXAMPLE
For an example of this command’s usage, see Appendix A, page
83, Example 3.
For an example of this command using the Caret feature see page
94, Example 3.
4-28