Download digi4park_general_commercial_presentation

Installation, Diagnosis and Troubleshooting
Digi4Park® A DIFFERENT WAY TO SOLVE PROBLEMS IN INSTALLATION
Digi4Park® includes two different systems to detect errors for the end user or during installation. In both cases, our idea is to
independently know where there is a problem and how to recognize it.
INSTALLATIONS WITHOUT GRAPHIC LED DISPLAY
In this case, two detection channels:
• If Display is available, it will display the number of faulty sensors and their
location (eg E2 - »2 faulty sensors). After 2 sec. will operate normally.
• In addition the unit itself has 2 LEDs (green and red) for the FRONT and for the
REAR to flash as many times as the number of faulty sensor has been located
(eg 3 blinks mean error in the sensor 3
INSTALACIONES GRAPHIC RADIO UNIT
When you can see the sensors on the screen of the vehicle, it is possible to see
faulty sensors during the 2 seconds immediately after the system is activated. The
faulty sensor will be shown as full contact.
If one of the sensors is not working, will not be represented in that image.
What if a sensor is defective, Digi4Park® work?
Digi4Park ® is able to operate with only one of the sensors connected