Download Model TB400G Surface Scattering Light Turbidity Meter

<6. PROCEDURES FOR CONVERTER OPERATION>
6-20
6.6 Operation in <PROGRAM1> Mode
In the <PROGRAM1> mode, data setting operations, such as output range, and operating status
setting operations, such as auto range selection, are carried out.
Function "1" to "F": Data settings
Function "1." to "F.": Operating status settings
Section 6.6 describes key operations which specify each function in the <PROGRAM1> mode
and the displays accompanying those key operations in the following order.
(1) Setting output ranges 1, 2, and 3
(2) Setting averaging coefficient (time constant)
(3) Setting output value if an error occurs
(4) Setting line-segment function output
(5) Setting change-over point in auto-ranging
(6) Setting high alarm value
(7) Setting low alarm value
(8) Setting turbidity value of calibration plate
(9) Setting zero-correction factor
(10) Setting sensitivity correction factor
(11) Setting detection level for spike detection function
(12) Setting hold time for spike detection function
(13) Setting sampling time for spike detection function
(14) Auto-range selection
(15) Remote range selection
(16) Local range setting
(17) Setting output hold in maintenance
(18) Setting output mode if a failure occurs
(19) Setting output hold for 4 mA or less
(20) Setting negative turbidity display hold
(21) Setting display-hold in automatic cleaning and calibration
(22) Selecting Suffix codes (sampling specifications)
(23) Selecting execution/stop of automatic cleaning function
(24) Selecting execution/stop of automatic calibration function
(25) Selecting designation of unit
(26) Selecting calibration plate or standard solution
(27) Selecting AUX (C1, C2) contact outputs
(28) Selecting execution/stop of spike detection function
IM 12E04A02-02E
6th Edition : Jan. 16, 2015-00