Download Spread Spectrum Wireless Data Transceiver User Manual

Spread Spectrum Wireless Data Transceiver User Manual
Factory Default Settings
FreeWave serial 900MHz transceivers are shipped from the factory with the following Default Settings:
Default
(0) Ethernet Mode
0
Point to Point Slave
1
(1) Half/Full Duplex
0
Set Baud Rate
Default
Operation Mode
Baud Rate
19200
(A) Data Parity
0
(B) Modbus RTU
0
(C) RS232/485
0
(D) Setup Port
3
(E) TurnOffDelay/OnDelay
0/0
(F) Flow Control
0
(2) Slave IP Stack
0
(3) Slave UDP Mode
0
(4) IP Address
255.255.255.255
(5) Port Address
65535
(6) IP Address 2
255.255.255.255
(7) Port Address 2
65535
(8) MAC Filter
0
MultiPoint Parameters
Default
(G) Use break to access setup
0
(0) NUMBER OF REPEATERS 1
Radio Parameters
Default
(1) MASTER PACKET
REPEAT
2
(2) MAX SLAVE RETRY
9
(3) RETRY ODDS
9
(0) FREQ KEY
5
(0) HOP TABLE VERSION
0
(1) HOP TABLE SIZE
112
(2) HOP FREQ OFFSET
0
(3) Frequency Zone
All 1’s (Enabled)
(1) MAX PACKET SIZE
8
(2) MIN PACKET SIZE
9
(3) XMT RATE
1
(4) RF DATA RATE
3
(5) RF XMT POWER
10
(6) SLAVE SECURITY
0
(7) RTS TO CTS
0
(8) RETRY TIMEOUT
255
(9) LOWPOWER MODE
0
(A) High Noise
0
(B) MCU Speed
0
(C) Remote LED
0
Ethernet Options:
Default
LUM0002AF Rev G
Version 6.3
(4) DTR CONNECT
0
(5) REPEATER FREQUENCY
0
(6) NETWORK ID
255
(7) RESERVED
-
(8) MULTI MASTER SYNC
0
(9) 1 PPS ENABLE DELAY
255
(A) SLAVE/REPEATER
0
(B) DIAGNOSTICS
0
(C) SUBNET ID
“Disabled”
Rx ID
F
Tx ID
F
(D) RADIO ID
Not Set
(E) Local Access
0
(G) Radio Name
Blank (?????????)
51