Download SimpleBGC 32bit 3-Axis Software User Manual

Transcript
6. RC Settings
from one direction to another, we can make three separate rotations by three axes. But the order of
rotations plays a role. You can change the order of rotations in the parameter “Order of Euler angles”. The
difference is displayed in the picture below:
YAW 360°
YAW 360°
PITCH
360°
PITCH
±90°
ROLL
360°
ROLL
±90°
CAMERA-ROLL-PITCH-YAW
CAMERA-PITCH-ROLL-YAW
Order of Euler angles
The default order is “Camera → PITCH → ROLL → YAW → Frame”. As you can see, it does not allow to roll
camera to angle greater that ±90 degrees, because in this case PITCH axis becomes equal to YAW axis and
the PITCH angle can not be distinguished from the YAW angle. Its recommended to set Min.angle=-85,
Max.angle=85 for ROLL axis in the “RC” tab, to not allow this case.
In opposite, if you select order “Camera → ROLL → PITCH → YAW → Frame”, you can roll camera to any angle
(including infinite 360 degree rotation), but can not pitch it more than ±90 degrees. The same, setting
Min.angle=-85 and Max.angle=85 for PITCH will help to prevent entering forbidden area.
NOTE: This setting is profile-based. It means that you can assign different Euler order to different profiles and switch
between them on-the-fly by menu button. Stabilization will be not interrupted.
"Cam – YAW – ROLL – PITCH" - This order of the axes is
needed for special cases when you need to point the camera
to a certain point on a ground and hold it at all pan and tilt
angles of a frame. In a typical case, the stabilization axes
PITCH and ROLL are rotated together with the rotation of the
camera (or a frame) by YAW axis. This means that if the
camera is looking down at a certain ROLL and PITCH angle,
and you pan the camera (or a frame in 2-axis system) - its
optical axis draws an arc, ie not locked to a point. If you
choose the order of the Euler angles "YAW-ROLL-PITCH", the
optical axis of the camera is always locked to a point on the
© Basecamelectronics® 2013-2015
YAW
ROLL
PITCH
PITCH
MOTOR
ROLL
MOTOR
28