Download Manual

Setup Mode
The Setup Editor
The Setup Editor
From Setup mode, press the Edit button to enter the Setup Editor, where you can make changes
to the currently selected setup. Use the soft buttons to select the various Setup Editor pages. The
upper line of each page displays the usual mode reminder, as well as the current Setup Editor
page, and the current zone. Use the Chan/Zone buttons to select one of up to sixteen different
zones, each having its own set of Setup Editor pages.
The parameters on the Setup Editor pages define what each of a setup’s zones sends—both to
internal programs and to the MIDI Out port. They also determine how the PC3LE responds to
MIDI signals received from a MIDI controller connected to the PC3LE’s MIDI In port (when the
Local Keyboard Channel matches the transmit channel of your MIDI controller).
The Control Setup
The Setup stored at ID# 126: Internal Voices has a special function in the PC3LE, and is referred
to as the Control Setup. Don’t edit the Control Setup unless you know what you’re doing, (see
The Control Setup on page 7-68 for details.)
Compare
Pressing the Storage button calls up the Compare Editor, which recalls the setup pre-edit
settings, allowing you to compare your edited setup with the original setup. Pressing the
Storage button again returns you to the Setup editor. Using the Compare Editor makes no
changes to the current setup.
The display diagrams you see in this chapter show the default values for setup 126 Internal
Voices.
Soloing a Zone
To solo a zone, set the Status parameter on the Setup Editor CH/PROG page (see below) to Solo
(or Solo+Muted). When a zone is set to Solo (or Solo+Muted,) the Chan/Zone buttons will
scroll through the zones of the current setup, soloing each zone. Change the Status parameter of
the current zone back to Active in order to stop soloing zones.
Additionally, you can configure a setup such that you can solo zones in real time (from outside
of the editor) by assigning any of the controller destinations to SoloZn. See Controllers (CTRLS)
Page on page 7-9 for more information on controller destination assignments in Setup mode. See
Set Controls Zone Mutes (MUTES) on page 7-65 for a way to automatically set the assignable
switches to mute zones.
KB3 Programs In Setup Mode
In Setup mode the assignable switches mute and unmute zones by default. If you want the
assignable switches to control the functions of a KB3 program in a setup, you can edit the setup
and automatically assign the KB3 controls using the KB3CTL soft button in the Setup Editor. See
Set Controls KB3 (KB3CTL) on page 7-65.
7-5