Download USER`S MANUAL

ASSEMBLY
• Assembly requires two persons.
• To identify small parts, see page 6.
•Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you finish all assembly steps.
•Assembly requires the following tools:
the included hex key
one adjustable wrench
•After shipping, there may be an oily substance
on the exterior of the treadmill. This is normal. If
there is an oily substance on the treadmill, wipe
it off with a soft cloth and a mild, non-abrasive
cleaner.
one Phillips screwdriver
To avoid damaging parts, do not use power tools.
1.
Make sure that the power cord is unplugged.
1
Place a piece of cardboard below the rear of the
Frame (56) to protect the floor or carpet.
Attach the Left Wheel Cap (96) to the Base (97)
with two #8 x 3/4" Screws (1).
Attach the Right Wheel Cap (not shown) to
the right side of the Base (97) in the same
way.
97
1
96
2.Pull the Upright Wire (84) and the base ground
wire (A) through the indicated hole in the Base
(97).
2
Attach the base ground wire (A) to the Base (97)
with a #8 x 1/2" Ground Screw (9).
Then, press the Grommet (81) into the square
hole in the Base (97).
84
Square
81
Hole
Hole
9
7
A
97
56
Cardboard