Download "user manual"

Hukseflux Thermal Sensors
5 Short user guide
Preferably one should read the introduction and first chapters to
get familiarised with the heat flux measurement and the related
error sources.
The sensor should be installed following the directions of the
next paragraphs. Essentially this requires a data logger and
control system capable of readout of voltages, and capability to
perform division of the measurement by the sensitivity.
The first step that is described in paragraph 6 is and indoor test.
The purpose of this test is to see if the sensor works.
The second step is to make a final system set-up. This is
strongly application dependent, but it usually involves
permanent installation of the sensor and connection to the
measurement system.
Directions for this can be found in paragraphs 7 to 11.
HFP01/ HFP03 manual version 0612
page 19/35