1
Download Setup
Transcript
Elevator Control Setup ! To Set Up Example 2 Reader/DO Configuration 1. In Configuration Type, select Reader/DO. 2. Click the Reader/DO Config button to display the following window. Figure 22-13. Reader/DO Config 3. Click the Reader button and select a reader from the picklist. The reader should be defined as an elevator reader. 4. For each floor, click the appropriate button and select an output from the picklist. This type of configuration supports up to 64 floors per micro. Click the Refresh Floor Defs button to update the floor labels if changes have been made since the Config window was displayed. 22.18 Picture Perfect 2.0 Administration Guide
