Download Processor Local Bus Functional Model Toolkit User`s Manual
Transcript
• Error 2.15.2 An error message is issued when Sln_rdWdAddr(0:3) is not aligned for line transfer 8.7.16 Sln_rdDAck The following error messages are issued for this signal: • Error 2.16.1 An error message is issued when Sln_rdDAck is asserted outside of the window from two clocks after the assertion of Sln_addrAck to one clock after the assertion of Sln_rdComp. • Error 2.16.2 An error message is issued when on a non-burst read transfer the slave fails to give the expected number of rdDAcks. • Error 2.16.3 An error message is issued when this signal is asserted during a DMA type=1,4,5,7 cycle from two clocks after Sln_addrack until one clock after Sln_rdComp is asserted. • Error 2.16.4 An error message is issued when this signal is asserted for a transfer that is outside of the slave’s assigned address space. • Error 2.16.5 An error message is issued when this signal is asserted more than once after the rdburst signal has been deasserted for a read burst transfer. 8.7.17 Sln_rdComp The following error messages are issued for this signal: • Error 2.17.1 An error message is issued when Sln_rdComp is active outside of allowed window from the cycle after slave asserts its Sln_addrAck to the cycle it asserts its Sln_rdComp. • Error 2.17.4 An error message is issued when more than one slave asserts Sln_rdComp in the same clock. • Error 2.17.5 An error message is issued when this signal is asserted before a variable length burst transaction is complete(last rddack received or rdbterm asserted). • Error 2.17.6 An error message is issued when this signal is asserted before the last rddack of the transaction is received. 8.7.18 Sln_rdBTerm The following error messages are issued for this signal: 80 Processor Local Bus Functional Model Toolkit Version 4.3