Download Processor Local Bus Functional Model Toolkit User`s Manual

Transcript
• Error 2.15.2
An error message is issued when Sln_rdWdAddr(0:3) is not aligned for line transfer
8.7.16 Sln_rdDAck
The following error messages are issued for this signal:
• Error 2.16.1
An error message is issued when Sln_rdDAck is asserted outside of the window from two clocks
after the assertion of Sln_addrAck to one clock after the assertion of Sln_rdComp.
• Error 2.16.2
An error message is issued when on a non-burst read transfer the slave fails to give the expected
number of rdDAcks.
• Error 2.16.3
An error message is issued when this signal is asserted during a DMA type=1,4,5,7 cycle from two
clocks after Sln_addrack until one clock after Sln_rdComp is asserted.
• Error 2.16.4
An error message is issued when this signal is asserted for a transfer that is outside of the slave’s
assigned address space.
• Error 2.16.5
An error message is issued when this signal is asserted more than once after the rdburst signal
has been deasserted for a read burst transfer.
8.7.17 Sln_rdComp
The following error messages are issued for this signal:
• Error 2.17.1
An error message is issued when Sln_rdComp is active outside of allowed window from the cycle
after slave asserts its Sln_addrAck to the cycle it asserts its Sln_rdComp.
• Error 2.17.4
An error message is issued when more than one slave asserts Sln_rdComp in the same clock.
• Error 2.17.5
An error message is issued when this signal is asserted before a variable length burst transaction
is complete(last rddack received or rdbterm asserted).
• Error 2.17.6
An error message is issued when this signal is asserted before the last rddack of the transaction is
received.
8.7.18 Sln_rdBTerm
The following error messages are issued for this signal:
80
Processor Local Bus Functional Model Toolkit
Version 4.3