Download 8XC196EA Microcontroller User`s Manual
Transcript
CHAPTER 9 SYNCHRONOUS SERIAL I/O (SSIO) PORT This device has a synchronous serial I/O (SSIO) port that shares pins with port 10. The SSIO provides two unidirectional serial communication channels or one synchronous bidirectional communication channel. The SSIO is compatible with most protocols because the serial clock is completely configurable. Paired, the SSIO channels can operate in a channel-select mode, allowing for communication in multiple-master systems without additional external hardware. Each SSIO channel can also perform handshaking transfers, which along with the PTS, provides unidirectional, multi-byte transfers with no CPU overhead. This chapter describes the SSIO port and explains how to program it. 9.1 SSIO PORT OVERVIEW The SSIO port has three modes of operation: standard, duplex, and channel-select. For singleslave, single-master systems requiring only one SSIO channel or two independent SSIO channels, use the standard mode of operation. In standard mode, each channel has a unique serial clock and data signal. For single-slave, single-master systems requiring two SSIO channels, use the duplex mode of operation. In duplex mode, the channels have unique serial data signals, but share a common clock signal. For systems with multiple masters or multiple slaves, use the channel-select mode of operation. Like duplex mode, in channel-select mode, the channels have unique serial data signals, but share a common clock signal. Channel-select mode provides an additional channel-select signal designed for communicating in systems with multiple masters or multiple slaves. In addition to three operating modes, the SSIO port can perform two types of data transfers: normal and handshaking. All modes support normal transfers, while only standard mode supports handshaking transfers. Normal transfers are compatible with most protocols because the serial clock is completely configurable. Handshaking transfers allow a slave device to notify the master that it is not ready for a transfer. “Normal Transfers (All Modes)” on page 9-9 and “Handshaking Transfers (Standard Mode Only)” on page 9-10 discuss these transfer types in detail. 9.1.1 Standard Mode In standard mode, the SSIO channels operate as two independent serial channels. Each channel contains one clock signal and one data signal. This mode is useful for systems in which unidirectional or half-duplex communication is acceptable. Half-duplex communication uses the same data signal for both transmissions and receptions. In standard mode, the channels can act as either master or slave and as either transmitter or receiver, resulting in the four configuration options shown in Figure 9-1. 9-1
Related documents
8XC196Lx Supplement to 8XC196Kx, 8XC196Jx, 87C196CA User`s
80296SA Microcontroller User`s Manual
8XC196NP, 80C196NU Microcontroller User`s Manual
8XC196NT Microcontroller User`s Manual
87C196JV 20 MHz ADVANCED 16
8XC196MC, 8XC196MD, 8XC196MH Microcontroller User`s Manual
87C196LA SPECIFICATION UPDATE
8XC196Kx, 8XC196Jx, 87C196CA Microcontroller Family
8XC196NP SPECIFICATION UPDATE
Casque Caldwell E-MAX LP Mode d`emploi
8X9X USER`S MANUAL
Intel 8XC196NT Computer Hardware User Manual