Download FAG Motion Guard CONCEPT6 CONTROL
Transcript
Setting greasing on the lubricator The greasing period is set using two keys on the lubricator. The display is fed by the internal battery, the connection cable must be free from voltage. Perform all steps according to Figure 12: ■ �: PIN reset to 00 by the following key combination: 2x MODE SAVE > 2x SELECT > MODE SAVE. The display disappears briefly and then reappears. ■ �: Set the greasing period, see table Greasing period, page 11. ■ �, � and ��: These settings are only effective when the distributor is connected, see BA 12, FAG Motion Guard C6MP-DISTRIBUTOR. 00016DD2 � Lubricator switched off � Display of time setting and PIN reset � PIN entry, first digit � PIN entry, second digit � Select LC unit volume � Set month, weeks or days � Change to days or weeks � Set outputs � Activate outlet 1 �� Activate outlet 2 �� Change PIN, first digit (for initial configuration or following PIN reset only) �� Change PIN, second digit (for initial configuration or following PIN reset only) �� Configuration complete Figure 12 Configuration menu Schaeffler Technologies BA 11 15