Download FAG Motion Guard CONCEPT6 CONTROL

Transcript
Setting greasing
on the lubricator
The greasing period is set using two keys on the lubricator.
The display is fed by the internal battery, the connection cable must
be free from voltage.
Perform all steps according to Figure 12:
■ �: PIN reset to 00 by the following key combination:
2x MODE SAVE > 2x SELECT > MODE SAVE.
The display disappears briefly and then reappears.
■ �: Set the greasing period, see table Greasing period, page 11.
■ �, � and ��: These settings are only effective when
the distributor is connected, see BA 12, FAG Motion Guard C6MP-DISTRIBUTOR.
00016DD2
� Lubricator switched off
� Display of time setting and PIN reset
� PIN entry, first digit
� PIN entry, second digit
� Select LC unit volume
� Set month, weeks or days
� Change to days or weeks
� Set outputs
� Activate outlet 1
�� Activate outlet 2
�� Change PIN, first digit
(for initial configuration or
following PIN reset only)
�� Change PIN, second digit
(for initial configuration or
following PIN reset only)
�� Configuration complete
Figure 12
Configuration menu
Schaeffler Technologies
BA 11
15