Download Flash Self-Programming Library Type01 User`s Manual

Transcript
RL78 Family
APPENDIX A REVISION HISTORY
Flash Self-Programming Library Type 01
APPENDIX A REVISION HISTORY
A. 1 Major Revisions in This Edition
Page
Description
Throughout the document
The English translation was reviewed and corrected.
-
Classification
(a)
-
The corresponding ZIP file name and release version were added to the cover.
(d)
-
The target device descriptions were deleted.
(c)
-
References to the list of the target MCUs were added.
(e)
The term "voltage mode" was changed to "flash memory programming mode"
for consistency of terminology.
Various types of operating frequency described in the former version were
unified to the CPU operating frequency.
A description regarding boot cluster 0 was added to the boot area.
(d)
-
Chapter 1 Overview
p.5
The FSL_IVerify state check processing was added to Figure 2-2.
(d)
(c)
(a)
Chapter 2 Programming Environment
p.14
A description of the case when flash functions are executed in the RAM was
added.
p.18
The formula for calculating the minimum time of FSL_BlankCheck was added.
(a)
p.19
(a)
p.24
In Table 2-4, the formula for calculating the processing time for each function
was corrected.
The resources used to run the flash self-programming library were corrected.
p.24
In Table 2-7, the description of the self-RAM area was changed.
(c)
p.24
In note 1 on Table 2-7, the inquiry about device specifications was changed.
(c)
p.25
The restriction on versions up to 2.10 was deleted from Figure 2-9.
(a)
p.26
A note was added to Table 2-8 Stack Size Used by Flash Functions.
(c)
p.28
The description of the self-RAM was reviewed and corrected.
(c)
p.28
The available range for stack and data buffer specifications was corrected.
(a)
p.30
In (3), the description of the functions that require special care regarding the
watchdog timer operation was reviewed and corrected.
In (18), note on the prohibition of 64KB boundary arrangement added.
(c)
P31
Chapter 6 Flash Function
In Table 6-1, the column of basic functions added and position and description
p.42
of note was changed.
The status check mode was corrected from the user mode to the internal
p.48 and p49
mode (in table titles, etc.).
Remark
(c)
(a)
(c)
(c)
(c)
“Classification” in the above table classifies revisions as follows.
(a): Error correction, (b): Addition/change of specifications, (c): Addition/change of description or note,
(d): Addition/change of package, part number, or management division,
(e): Addition/change of related documents
R01US0050EJ0103
Dec 22, 2014
Rev.1.03
Page 108 of 109