Download USER`S MANUAL

INSTALLATION ARCHTTP PROXY SERVER
5. Installation ArcHttp Proxy Server
Overview
After the hardware installation, the SATA disk drives connected to the
SATA RAID controller must be configured and the volume set units initialized before they are ready to use.
Those user interfaces can access the built-in configuration and administration utility that resides in the controller’s firmware. They provide
complete control and management of the controller and disk arrays,
eliminating the need for additional hardware or software.
The software utility refers to SATA RAID controller software on the CDROM delivered with your system. This CD-ROM contains the software
utility that is required for the monitor, test, and support of SATA RAID
controller. The software utility and McRAID storage manager can configure and monitor the SATA RAID controller via ArcHttp Proxy Server.
The following table outlines their functions:
Configuration Utility
McBIOS RAID Manager
Operating System supported
OS-Independent
McRAID Storage Manager
(Via Archttp proxy server)
Windows 2000/XP/2003, Linux and
FreeBSD
SAP Monitor
(Single Admin portal to scan for multiple RAID units in the network, Via
ArcHttp Proxy Server)
Windows 2000/XP/2003
Java based for Windows.
Linux and FreeBSD (available in Q2,
2005)
SNMP Manager Console Integration
(Via ArcHttp Proxy Server)
Windows 2000/XP/2003, Linux.
FreeBSD (available in Q2, 2005)
5.1 For Windows
You must have administrative level permission to install SATA RAID
software. This procedure assumes that the SATA RAID hardware
and windows are installed and operational in your system.
Screen in this section are taken from a Windows/XP installation.
If you are running other Windows, your installing screen may look
different, but the ArcHttp proxy server installation is essentially the
same.
1. Insert the RAID subsystem CD in the CD-ROM drive.
2. Run the setup.exe file that resides at: <CD-ROM>\windows\
http\setup.exe on the CD-ROM.
88